AccessPORT maps and discussion related specifically to the Impreza WRX STI
Here's the link to download the user's guide for the 2004-2006 STI. http://www.accessecu.com/support/ap-usersguide-sti.pdf
These Map Downloads are for the AccessPORT Ver 2.0 Only!! 2004 STI Ver 2.0 Map Downloads ...
2004 WRX STi Map Download Click Here! ...
Just installed new stage 2 +aem intake 93oct map and my car is running fine but will only hit a peak boost of 17.5psi. Any one have any suggestions...
Hi, My car is 08 STi stage 1. I'm a little bit confused by all the timing tables. I decided to re-tune the car due to the installation of a...
I have a 2010 STi currently at stage 1 93. Posted over at iwisti, but haven't really gotten answers in full. I did a couple logs...DAM = 1, max...
I used the newest version of AccessPORT updater and updated my AccessPORT v2. When I was getting ready to go out for the evening, I checked the...
I just put the AEM intake on my 08 sti a few weeks ago and I am now running your new stage 2 cai map. My question is; am I still able to run the...
Hey guys, I recently am starting to use my ver2.0 AP on my 06 STi. The problem I'm having is that when I connect it to my computer, it acts as if it...
My base map is stage1 93, and I have a realtime map of stage1 91. I now want to be using stage1 93, so do I just need to make the RT stage1 93? Or...
I have a SPT intake, so I can easily hear the air that is rushing in. Since I installed AP, sometimes when I have it floored the intake is making a...
2010 STi MXP TBE AEM CAI Using the Cobb Stage 2 Map for AEM on 93 gas. Located in Louisiana with high humidity and 95 degrees. I did a 3rd...
I just installed AP on my 05 STi last night and took it out for a spin and recorded the data log. I attached it as 'base 93oct.' The DAM wasn't...
Is a SPT CBE within the mod. limits of stage 1, or do I have to go straight to stage 2 and get the dp. I would like to start out at stage 1 and see...
When your DAM hits ZERO it shuts off the trubo. Try a reset. A reset puts the DAM at 0.5 I think and it allows the turbo to work. Your vehicle may...
Dear Cobb, I am a huge cobb fan... had cobb products on my 2003 WRX all the way up to my 2008 STI (Cobb Downpipe and Accessport). I am...
I have a 2010 sti with a turbo-back exhaust and an AMR intake and was wondering where i could get a map that would suit this set up? Thanks in...
I have my launch RPM's at 4K and things seem to work fine but I noticed a kerchunk when dropping the clutch for the first time. I am guessing I...
http://blogs.cobbtuning.com/wp-content/uploads/2010/06/STIap.jpg COBB Tuning is proud to announce the release of AccessPORT Stage2 AEM Cold Air...
i got my AP last friday and installed it staturday without hickups.. Today I loaded the Stg1 93oct 1.04 realtime (flash is on stock 1.04) map and...
I'm considering getting methanol/water injection (50/50) for reliability reasons (i.e. lower EGTs and higher octane, thus less likely to knock), not...
ok so i know yall are gonna chew my butt (im a newbie to this stuff keep that in mind, i just eneed some feedback) but i am running stage 1 with all...
Hello guys, I have an AP V2 that has been programmed by Jarrad at PDX tuning by way of its online map upgrade service, as I don't have a reputable...
Use this control to limit the display of threads to those newer than the specified time frame.
Allows you to choose the data by which the thread list will be sorted.
Order threads in...
Note: when sorting by date, 'descending order' will show the newest results first.
Forum Rules
