Valet Mode

[Nick Haman]

I am trying to do a valet mode in map slot 0. Since Rev limits are part of the base map, I am trying to use throttle mapping to limit the power. This is my map:

throttle.JPG

Works fine until WOT, then it jumps immediately to 100%. Is there a workaround?

[Bailey]

Hi Nick
I've never done a valet map using this method. The next time i have a car at my disposal i'll test your settings and see if i can figure it out.

For now, because you have to "flash" a new map anyway i'd simply add a lower boost limit, and a low rev limit and call it done. How much trouble can a valet get into with a 3000 RPM limit??

Best regards
Tim Bailey

[Nick Haman]

Hi Nick
I've never done a valet map using this method. The next time i have a car at my disposal i'll test your settings and see if i can figure it out.

For now, because you have to "flash" a new map anyway i'd simply add a lower boost limit, and a low rev limit and call it done. How much trouble can a valet get into with a 3000 RPM limit??

Best regards
Tim Bailey

Thanks for the tip Tim. I know I can reflash with a lower RPM limit in a base map, but even with the fast reflash it takes ~1 minute. I would like to do this with the live map switching. Any new ideas on this topic?

--Nick

[Bailey]

Thanks for the tip Tim. I know I can reflash with a lower RPM limit in a base map, but even with the fast reflash it takes ~1 minute. I would like to do this with the live map switching. Any new ideas on this topic?

--Nick

Hi Nick
No additional ideas on my part. When i get another car into the shop i'll do some testing on my own. Until then you'll need to flash a map with a lower REV limit. You might as well put in a lower boost limit too (also a base map parameter).

Regards
Tim Bailey