ATR + Zeitronix Zt-2 WBO2/Boost = slight issue

[hicksta13]

I have the Zeitronix Zt-2 WBO2 system with the boost sensor in my 08 Legacy GT Limited. I found the instructions to log AFR and boost from the Zt-2 in ATR here on the forums, and got everything set up. When I begin to log everything is fine at first. After a few minutes though, the data from the Zt-2 locks up (i.e. AFR - 14.3, Boost, -21.0). I suspect the MAIN issue is the serial to USB adapter, which I purchased from Zeitronix. I do have the correct drivers installed and ATR is set to recognize COM4 when the Zt-2 is connected. I thought the number of monitors may have been an issue, but I'm logging only what I need per my tuner. Here are the monitors I have selected:

A/F Learning #1
A/F Learning #3
Calculated Load
DAM
Engine Speed
Fine Knock Learning
Ignition Timing
Inj. Duty Cycle
MAF
MAF Voltage
Throttle Position
Wastegate Duty
ZT2 - AFR
ZT2 - Boost

I appreciate any feedback and/or suggestions!!!

[hicksta13]

Still not having any luck. After speaking with Chris at Cobb, I removed the dlls for the WBO2 sensors I don't have and verfied again I was on the same COM port. When I connected everything this morning, AFR locked up immediately. I tried it again a little later and it worked for about 90 seconds and then locked up. I also started monitoring Manifold Rel. Pressure instead of Zt2 - Boost. Still no dice, and any suggestions would really be appreciated because I'm at a total loss . Current monitor list follows:

A/F Learning #1
A/F Learning #3
Calculated Load
DAM
Engine Speed
Fine Knock Learning
Ignition Timing
Inj. Duty Cycle
Manifold Rel. Pressure
MAF
MAF Voltage
Throttle Position
Wastegate Duty
ZT2 - AFR